BOGE Controllers





BOGE Controllers

Master controls for multiple compressor stations make compressed air production significantly more efficient – especially in cases where compressed air consumption fluctuates or where speed-regulated compressors are integrated into the network.

 




Model Description
Trinity-16

Controls 3 compressors - Complete with connection modules - Pressure Transducer 16 Bar


Enquire
Trinity-40

Controls 3 compressors - Complete with connection modules - Pressure Transducer 40 Bar


Enquire
Airtelligence Plus-16

Controls 6 Compressors including VSD - Pressure Transducer 16 Bar


Enquire
Airtelligence Plus-50

Controls 6 Compressors including VSD - Pressure Transducer 50 Bar


Enquire
AP Modbus RTU

Modbus RTU RS485 Connection interface for Airtelligence Plus


Enquire
Airtelligence Provis2-16 IPC

Controls 16 Compressors including VSD - Pressure Transducer 16 Bar - IPC & Basic Visualisation included


Enquire
Airtelligence Provis2-50 IPC

Controls 16 Compressors including VSD - Pressure Transducer 50 Bar - IPC & Basic Visualisation included


Enquire
AP2 PT-16

Additional 16 Bar Pressure Transducer for Provis 2


Enquire
AP2 PT-50

Additional 50 Bar Pressure Transducer for Provis 2


Enquire
AP2 Modbus RTU

Modbus RTU RS485 Connection interface for Provis 2


Enquire
AP2 Profibus

Profibus Connection Interface for Provis 2


Enquire
AP2 Airlogic

Programmable Logic for Provis 2


Enquire
AP2 Visualisation

Visualisation including Analysis, reports & Remote Monitoring of faults, alarms, etc


Enquire
Airstatus switch cabinet version

Controller in in cabinet


Enquire
Rod Antenna

Antenna with 30m connection cable in combination with GSM/GPRS


Enquire
Comms Module

Required for Run/ Ready/ Fault signals from Base Board Compressors/ Other manufacturers


Enquire
AP Connection Module*

Connection of Compressors for Airtelligence Plus & Provis 2


Enquire
AP Power-24V

Power Supply for Connection module if 24V supply is not available in control box


Enquire


* Connection module is also used for connecting ancillary items.  Each module has the following I/O: –
2x analogue inputs 4-20mA – Free scaling of value range  (e.g. flow meters, dew point, temperature, etc)
1x analogue output 4-20mA – Free scaling of value range (e.g. to display an analogue signal somewhere externally)
4x digital inputs 24V – Freely definable denotation (e.g. Faults, Valve Open/ closed, equipment on/ off)
2x digital outputs – Programmable using 7 day timer